Cold Weather Is On Its Way

COLD weather is on its way.  Please find below a couple of tips that can help keep your Clean Burn running properly during this cold snap.

• Monitor the oil supply in your tank.  Make sure you have sufficient good oil.  With this extremely cold weather, you will use oil at a much faster rate.  Make sure there is plenty of oil in the tank to last over night.  Make sure your oil is not contaminated with antifreeze, water or sludge.  Please see the list below for approved oils.

          Crank case oil

          Transmission Fluid

          New Fuel Oil # 2, #4, and #5

          Synthetic Used oil

          Hydraulic Fluid (up to 90 Weight)

          Diesel Oil and Diesel Fuel (New or Used)

• Make sure your air compressor is in a warm environment .   Make sure there is no water in your air compressor or the air compressor line.  Water in the air compressor could freeze and cause your air compressor not to work.  Your furnace will not operate without air coming from your air compressor.

Before You Start Up Your Furnace

Required Steps Before You Start Up Furnace

• ·        Make sure air compressor is on
• ·        Make sure electric has been on at least 15 minutes
• ·        Inspect oil for contaminents
• ·        Measure oil in tank, must contain more than 21”
• ·        Swing open burner, inspect CAD cell, electrodes and nozzle; clean if necessary
• ·        Turn thermostat up to call for heat

After above is complete, you can start up your furnace